Regarding the use of small electric all-servo tube bender, what preparations need to be made before starting up? In addition, if there is a problem during the use of the user, how should it be handled in time? So let's talk about it in detail.

First, before starting the machine, the user needs to make some preparations for the all-servo tube bender. Before starting, the user needs to check whether the electrical equipment is loose, because in the process of transportation, the user may be due to the incorrect mode of transportation or handling, resulting in the loosening of the screws of the equipment. In this case, it is necessary to tighten the screw in time to avoid other effects caused by the loosening of the screw.

Second, the ground on which the all-servo tube bender is located must be smooth, and there should not be too large slope to avoid severe vibration during the operation of the all-servo tube bender, which will cause damage to the machine.

Third, after checking the surrounding environment, the user can directly connect the power supply to the bender to see whether the operation of its equipment is normal, first turn on the control power switch, check whether the direction of the oil pump motor is accurate, generally in accordance with the clockwise front turn, if the direction is not correct, it may be the wrong position of the power cord. At this time, the power cord can be reversed, and the operation can be officially started without any error.

In short, generally speaking, all-servo tube bender is mainly rotated by turbine gearbox. Therefore, during the operation of all-servo tube bender, we should ensure the uniform bending radius area. The bend within 180 degrees can be adjusted normally, if it is for the bend of about 90 degrees, it can be formed at one time.

all-servo tube bender https://www.john-sheng.com/All-Servo-Tube-Bender